Shop boom truck fall hazard warning decals, three-point-contact reminders and no-riding labels. Compare messages about machine access, surfaces that are not steps, riding on crane components and hoisting personnel on the loadline.
This collection also includes a tipping-hazard warning and a hoist-drum cable-wedge warning. Select by the complete printed message, not the collection name alone.
The three-point-contact design instructs personnel not to jump from the machine and to face the access system while using three-point support during entry and exit.
The Not a Step label communicates a different restriction: the marked surface should not be used as a step. It does not identify an alternative safe foothold.
Match each label to the machine’s designated access arrangement and manufacturer instructions. These reminders do not provide fall protection or replace equipment-specific access guidance.
The no-riding warning addresses the boom, hook, load, loadline and attached devices. The Never Hoist Personnel on Loadline design carries a separate personnel-hoisting warning.
Compare the exact wording, symbols and dimensions before ordering. Neither design identifies a personal fall-protection anchor or establishes an approved method for lifting personnel.
The tipping-hazard label and proper cable-wedge warning address different equipment and operating concerns from access labels.
Check the complete artwork and application details on each listing. Do not assume that an instruction applies to every boom truck, crane configuration or hoist assembly.
Use manufacturer-designated labeling locations where available. Position access reminders where personnel can read them before climbing, and other warnings where the intended operator or service personnel can read them before the relevant task.
Keep labels on suitable fixed surfaces without covering controls, viewing areas, identification plates or other required markings.
Sizes, materials and quantities vary by product. These individual labels are not a complete model-specific replacement decal kit. They communicate warnings and instructions but do not replace training, inspections or safe operating procedures.
For a different size or message, call 419-677-5035 or contact us to discuss available options.
