Underground Services & Overhead Wires Danger Sticker

DNGR-006

This underground services and overhead wires danger sticker reminds equipment operators to be aware of utility hazards both below ground and above the machine. A red DANGER header sits between two yellow triangular pictograms showing a digging-related underground hazard and overhead electrical wires.

Use it as an equipment-mounted reminder about underground utilities and overhead lines, not as a marker identifying the location of a buried service.

Full printed warning

DANGER
BE AWARE
OF UNDERGROUND
SERVICES AND
OVERHEAD WIRES

Size and product details

  • Size: 4¾ inches wide × 1¾ inches tall.
  • Product code: DNGR-006.
  • Laminated adhesive safety sticker.
  • Red DANGER header, black wording on white and two yellow utility-hazard pictograms.
  • Created, printed, cut and shipped in the USA.

Recommended placement

As a general recommendation, place the warning on a visible operator-facing panel beside the controls used for digging or raising equipment, where it can be read before work begins. For cab-operated equipment, choose a panel visible from the seated operating position. For an exterior control station, use the corresponding control-station panel rather than relying only on a label inside the cab.

This is general placement guidance, not a verified factory location for a particular machine. Match the original warning location and manufacturer's instructions when replacing a label. Keep controls, instruments, load charts, viewing areas and existing warnings unobstructed.

Before ordering

Compare the printed wording, pictograms and listed dimensions with the warning you need. The decal does not locate underground services, specify a safe power-line clearance or confirm that a work area is clear of utilities. It is not a utility-location marker, excavation permit, electrical protective device or complete operating procedure. Follow the equipment manufacturer's instructions and the site's utility-location and overhead-line precautions.

For help matching a replacement, contact us with a photo of the original warning and its dimensions.

Technical & Safety Data

Product Composition & Identification

Film Construction: 2.75 mil Polymeric Calendered Vinyl base paired with a 2.75 mil flexible clear Polymeric Calendered Vinyl overlaminate.

Adhesive System: Clear Solvent-Based Permanent Pressure Sensitive Acrylic.

Total Adhesive Thickness: 2.3 mil combined (1.2 mil base and 1.1 mil laminate).

Health, Safety & Regulatory Compliance

Fire Rating: Class A fire rating under ASTM E84-17 testing.

Commercial Safety: Meets the highest life safety requirements for indoor and outdoor commercial graphics.

Toxicity & Structure: Phthalate-Free Film Structure.

Regulatory Standards: Meets the health and safety requirements set forth by CPSIA, REACH, RoHS, and California Proposition 65.

Physical & Chemical Properties

Chemical Resistance: Resists mild acids, mild alkalis, solvents, and salts.

Moisture Resistance: Excellent resistance to water, including full immersion.

Tensile Strength: 12.5 Pounds/Inch.

Dimensional Stability: 0.020 Inch (Machine Direction).

Peel Adhesion: 4.5 Pounds/Inch from Stainless Steel.

Environmental & Temperature Tolerances

Operating Temperature Range: -40°F to 190°F.

Application Temperature: 50°F to 80°F recommended.

Installation Surface: Clean, dry, and free of dust, dirt, debris, or grease.

Outdoor Lifespan: Up to 5 years permanent durability.

Search