This
3 points of contact warning sticker reminds operators to face the access system and use three-point support when entering or leaving equipment. Its horizontal design combines a climbing illustration, an orange WARNING header, printed access reminders and a yellow fall-hazard symbol.
Why use a three points of contact sticker?
Entering and exiting equipment exposes operators to a fall hazard at the steps, ladder or cab entrance. A three points of contact sticker puts a visible reminder at that access point: keep two hands and one foot, or two feet and one hand, in contact with suitable handholds and steps while climbing. Its printed instructions also remind operators not to jump off the machine and to keep the steps clean.
The sticker measures
6 inches wide × 2 inches tall.
Printed wording
WARNING
FACE ACCESS SYSTEM & USE THREE POINT
SUPPORT DURING INGRESS & EGRESS
- Never Jump Off Machine
- Climb Up Forwards
- Down Backwards
- Ensure The Steps Are Clean
What are three points of contact?
Three points of contact means maintaining two hands and one foot, or two feet and one hand, on suitable handholds and steps while climbing. Ingress means entering; egress means leaving. The printed “Down Backwards” reminder refers to descending while facing the access system, not turning away from it.
Product details
- Size: 6 inches wide × 2 inches tall.
- Product code: WRN-007.
- Laminated adhesive safety sticker.
- Climbing illustration on the left, access instructions in the center and fall-hazard pictogram on the right.
- Created, printed, cut and shipped in the USA.
Recommended placement
As a general recommendation, place the label on a visible fixed panel beside the equipment's steps, ladder or cab entrance, where it can be read before climbing. Consider visibility both from the ground before ascending and from the exit before descending; a label visible only from the seated operating position may miss the access point.
This is general guidance, not a verified factory location. Follow the equipment manufacturer's required warning and location. Keep the sticker off step treads, gripping surfaces, moving joints and areas subject to foot traffic, and do not obscure existing warnings or controls.
Check before ordering
Compare the wording, dimensions and available mounting space with the label required for your equipment. The sticker is an access reminder, not a handhold, fall-protection device or substitute for the manufacturer's access procedures.
View our other three-point ingress and egress sticker design.
Read our guide to the three points of contact rule.
For help matching an existing warning,
contact us with a clear photo, label dimensions and equipment details.