Outrigger Extension Warning Sticker – Position & Capacity Limiter Settings

WRN-016

This outrigger extension warning sticker pairs a printed setup warning with diagrams labeled for intermediate and fully extended outrigger positions. WRN-016 measures 7 inches wide × 6½ inches tall and has an orange WARNING header.

Full printed wording

WARNING

Improper extension of outriggers can lead to serious personal injury and/or equipment damage. Use only specified outrigger positions with corresponding rated capacity limiter settings.

INTERMEDIATE EXTENDED OUTRIGGER POSITION

FULLY EXTENDED OUTRIGGER POSITION

DO NOT DEFACE OR REMOVE THIS LABEL FROM MACHINE

Check the illustrated positions before ordering

The lower section shows two outrigger-extension diagrams beside corresponding pin-position illustrations. Compare the complete artwork, wording and 7 × 6½-inch dimensions with the warning specified for your equipment.

Do not assume these illustrations match every crane’s outrigger or locking-pin arrangement. This sticker does not provide a load chart, identify every permitted setup or specify the capacity-limiter setting for a particular lift.

Placement near the setup area

Follow the equipment manufacturer’s designated decal location when available, preserving the original location when replacing a matching warning.

As general guidance, select a fixed panel where the person setting up the outriggers can read the warning before selecting an extension position. Keep the label visible without covering controls, position markings, identification or other instructions. These are general recommendations, not verified factory locations for a specific model.

Warning label, not a setup verification

The decal communicates the pictured warning. It does not lock the outriggers, confirm pin engagement, select capacity-limiter settings or establish equipment stability. Follow the manufacturer’s setup instructions and the applicable load chart for the actual configuration.

For help matching this replacement or discussing a different size, contact Crane Safety Stickers or call 419-677-5035.

Technical & Safety Data

Product Composition & Identification

Film Construction: 2.75 mil Polymeric Calendered Vinyl base paired with a 2.75 mil flexible clear Polymeric Calendered Vinyl overlaminate.

Adhesive System: Clear Solvent-Based Permanent Pressure Sensitive Acrylic.

Total Adhesive Thickness: 2.3 mil combined (1.2 mil base and 1.1 mil laminate).

Health, Safety & Regulatory Compliance

Fire Rating: Class A fire rating under ASTM E84-17 testing.

Commercial Safety: Meets the highest life safety requirements for indoor and outdoor commercial graphics.

Toxicity & Structure: Phthalate-Free Film Structure.

Regulatory Standards: Meets the health and safety requirements set forth by CPSIA, REACH, RoHS, and California Proposition 65.

Physical & Chemical Properties

Chemical Resistance: Resists mild acids, mild alkalis, solvents, and salts.

Moisture Resistance: Excellent resistance to water, including full immersion.

Tensile Strength: 12.5 Pounds/Inch.

Dimensional Stability: 0.020 Inch (Machine Direction).

Peel Adhesion: 4.5 Pounds/Inch from Stainless Steel.

Environmental & Temperature Tolerances

Operating Temperature Range: -40°F to 190°F.

Application Temperature: 50°F to 80°F recommended.

Installation Surface: Clean, dry, and free of dust, dirt, debris, or grease.

Outdoor Lifespan: Up to 5 years permanent durability.

Search