Crane Outrigger Setup Warning Sticker – OSHA Danger Header, I-013O

This crane outrigger setup warning sticker reminds operators to check pins, floats, and outrigger-beam extension before lifting on outriggers. I-013O measures 4¾ inches wide × 3¾ inches tall and features an oval OSHA danger header with white DANGER lettering on red, set against black.

Printed outrigger setup warning

DEATH OR SERIOUS INJURY COULD RESULT FROM IMPROPER CRANE SET-UP ON OUTRIGGERS.

ENSURE ALL PINS AND FLOATS ARE PROPERLY INSTALLED AND THE OUTRIGGER BEAMS ARE PROPERLY EXTENDED BEFORE LIFTING ON OUTRIGGERS.

Match the reminder to your equipment

This adhesive vinyl label addresses setup before lifting, rather than telling bystanders to stand clear during outrigger movement. Compare its complete wording, oval danger header, and dimensions with your existing label and manufacturer documentation before choosing it as a replacement.

The artwork says “properly extended,” not that every crane must use one fixed beam-extension position. Use the equipment manufacturer’s instructions and applicable load chart for the actual configuration. This sticker does not specify extension distances, load capacities, ground-bearing-pressure limits, or leveling tolerances.

Placement and application

As general guidance, choose a visible position where the operator can read the reminder during setup and before lifting. Use the manufacturer’s decal-location diagram and your facility’s procedures to determine the exact location. No model-specific mounting position is established by this product page.

Apply to a suitable clean, dry surface without covering controls, nameplates, load charts, or existing warnings. The label supplements operating instructions, inspections, and training; it does not verify correct setup or establish equipment compliance. “OSHA danger header” describes the artwork.

Contact us if you need help comparing the wording or size before ordering. Created, printed, cut, and shipped in the USA.