Aerial Lift Electrocution Hazard Sticker

This aerial lift electrocution hazard sticker warns operators to maintain clearance from electrical power lines and apparatus while allowing for platform sway, rock or sag. It also carries the warning about contact with, or proximity to, electrically charged conductors while in contact with or near another conductor.

Printed wording

DANGER
ELECTROCUTION HAZARD

• Maintain safe clearances from electrical power lines and apparatus. you must allow for platform sway, rock, or sag.
• This aerial device does not provide protection from contact with or proximity to an electrically charged conductor when you are in contact with or in proximity to another conductor.

DEATH OR SERIOUS INJURY
will result from such contact or inadequate clearance.

Product details

• Listed size: 4 inches wide × 5 inches tall.
• Product code: EAL-002.
• Red DANGER header with an exclamation symbol, black wording on white and red emphasis on “DEATH OR SERIOUS INJURY.”
• Text-based electrical hazard warning with two printed bullet points.

Choosing the correct electrical warning

Compare the complete message, dimensions and intended application with the aerial device manufacturer's replacement-label instructions. This label does not print a clearance distance or voltage table, and it does not establish an equipment insulation rating.

The sticker communicates the warning; it does not provide electrical protection or replace the manufacturer's instructions, applicable electrical work procedures, training or job-specific clearance planning.

Recommended placement

As general guidance, use a visible operator-facing fixed panel at the relevant aerial lift control station or platform access point, where the message can be read before operation. If ground and platform control stations are separate, follow the manufacturer's marking instructions for each rather than assuming one label serves both.

Use the specified factory label position when available. A model-specific mounting location has not been verified here. Keep controls, instruments, capacity and identification plates, insulation markings and other required warnings unobstructed.