Three Point Contact Warning Sticker – Do Not Jump from Machine

This three point contact warning sticker combines a “DO NOT JUMP FROM MACHINE” message with a reminder to face the access system and use three point support during entry and exit. A climbing figure beside the text has three circled contact points, under a red DANGER header with a triangular alert symbol.

Printed Entry and Exit Warning

DANGER

DO NOT JUMP
FROM MACHINE

FACE ACCESS SYSTEM
& USE THREE POINT
SUPPORT DURING
INGRESS & EGRESS

3 POINT CONTACT

“Ingress” and “egress” refer to entry and exit. This label communicates an access reminder, not a complete climbing procedure or a substitute for the equipment manufacturer's access instructions.

Warning Decal Details

• Size: 6¼ inches wide × 3½ inches tall
• SKU: FC-002
• English-language horizontal design
• Red climbing figure with three circled contact points
• UV-resistant vinyl
• Created, printed, cut and shipped in the USA

Choosing Your Replacement Sticker

Compare the printed wording, dimensions and layout with the warning specified for your equipment. This is an adhesive warning decal, not a rigid sign, handhold, step or fall-protection device. It does not certify an access system, prevent falls or establish OSHA, ASME or ANSI compliance.

For a Spanish-language alternative, see the Spanish three point contact warning sticker, FC-002SP. Both measure 6¼ inches wide × 3½ inches tall, but their climbing illustrations differ. Review the wording and artwork when choosing a replacement.

For another design, see our alternative 3 points of contact sticker. Read the three points of contact explanatory article for related information.

Recommended Placement

For cranes and boom trucks, we recommend a visible fixed panel beside the designated cab-access steps or ladder, where the reminder can be read before climbing. For crawler cranes, follow the manufacturer's specified warning locations at the designated access ladder or walkway entrance. Where there are separate entry and exit routes, follow the decal map for each route rather than assuming one label is visible from both directions.

These are general recommendations, not verified factory locations for every model. Preserve the original warning-label position when known and follow the manufacturer's decal-location guidance. Do not cover step treads, handhold gripping surfaces, controls, identification plates or other warnings. Follow the decal's application instructions and prepare a clean, dry mounting surface.