Do Not Walk on Hood Sticker – Machinery Safety Instructions

I-054

This Do Not Walk on Hood sticker identifies a hood that should not be used as a walking surface. I-054 measures 3½ inches wide × 4½ inches tall and features a green SAFETY INSTRUCTIONS header above an illustration of a person falling from a sloped surface.

Full printed wording

SAFETY INSTRUCTIONS

To Prevent Personal Injury, Do Not Walk On Hood.

Check the replacement label

Compare the wording, illustration, green header and 3½ × 4½-inch dimensions with the label specified for your equipment.

This design gives a specific instruction about the hood. It does not identify an approved walking route, establish the hood’s load-bearing capacity or provide an anti-slip surface.

Placement and application

Follow the equipment manufacturer’s designated decal location when available, preserving the original position when replacing a matching label.

As general guidance, position the sticker where someone can read it before attempting to step onto the hood. Keep it visible without covering controls, service information, identification or other warnings. These are general recommendations, not verified factory locations for a particular model.

Apply to a suitable clean, dry surface. Do not climb onto the hood to install the sticker.

Use designated equipment access

The sticker communicates the printed instruction; it does not provide a step, handhold, guard or fall-protection system. Follow the manufacturer’s designated access routes and service procedures.

For help matching this label or discussing a different size, contact Crane Safety Stickers or call 419-677-5035.

Technical & Safety Data

Product Composition & Identification

Film Construction: 2.75 mil Polymeric Calendered Vinyl base paired with a 2.75 mil flexible clear Polymeric Calendered Vinyl overlaminate.

Adhesive System: Clear Solvent-Based Permanent Pressure Sensitive Acrylic.

Total Adhesive Thickness: 2.3 mil combined (1.2 mil base and 1.1 mil laminate).

Health, Safety & Regulatory Compliance

Fire Rating: Class A fire rating under ASTM E84-17 testing.

Commercial Safety: Meets the highest life safety requirements for indoor and outdoor commercial graphics.

Toxicity & Structure: Phthalate-Free Film Structure.

Regulatory Standards: Meets the health and safety requirements set forth by CPSIA, REACH, RoHS, and California Proposition 65.

Physical & Chemical Properties

Chemical Resistance: Resists mild acids, mild alkalis, solvents, and salts.

Moisture Resistance: Excellent resistance to water, including full immersion.

Tensile Strength: 12.5 Pounds/Inch.

Dimensional Stability: 0.020 Inch (Machine Direction).

Peel Adhesion: 4.5 Pounds/Inch from Stainless Steel.

Environmental & Temperature Tolerances

Operating Temperature Range: -40°F to 190°F.

Application Temperature: 50°F to 80°F recommended.

Installation Surface: Clean, dry, and free of dust, dirt, debris, or grease.

Outdoor Lifespan: Up to 5 years permanent durability.