This
power line clearance danger sticker displays separate diagrams for overhead power lines on poles and towers, alongside printed special provisions. Red, yellow and green zones illustrate the distances and spotter references shown on the artwork.
The decal measures
8 inches wide × 4 inches tall. It is a replacement warning chart, not a site-specific clearance assessment. Confirm that the printed chart is appropriate for your equipment, line voltage, work activity and applicable requirements before selecting it.
Printed heading and diagram text
DANGER
Clearance for Operating Equipment Near Power Lines
Diagram headings:
Overhead Power Lines on Poles
Overhead Power Lines on Towers
Both diagrams display the following zone wording:
-
NO GO ZONE: Anywhere Above Power Line and within 3M 10F Each Side. See Special Provisions.
-
Spotter Required: Between 10' - 21' Feet Of Power Lines.
-
Open Area: Outside 21' Feet Of Power Lines.
The diagrams also include 10' horizontal and 20' vertical dimension labels. These are transcriptions of this product's artwork, not a recommendation that those distances apply to every operation.
Full printed special provisions
- Ensure "Spotter" is provided.
- Notify the Power Company when planning the work.
- Obtain written permission from the Power Company.
- DO NOT commence work until a pre-stat site/job meeting and risk assessment have been completed.
The term "Spotter" is defined as a safety observer who is a person competent for the sole task of observing and warning against unsafe approach to overhead power lines and other electrical apparatus.
The wording “pre-stat” above appears on the artwork.
Product details
- Size: 8 inches wide × 4 inches tall.
- Product code: DNGR-008.
- Laminated adhesive safety sticker.
- Red DANGER header, pole and tower illustrations, and color-coded zones.
- Created, printed, cut and shipped in the USA.
Recommended placement
As a general recommendation, use a visible operator-facing panel beside the controls for equipment that can approach overhead power lines. Choose a location readable from the operating position before raising or moving the equipment. For an exterior operating station, use the corresponding control panel rather than relying only on a chart inside the cab.
This is general guidance, not a verified factory location. Match the manufacturer's required label and location, and keep controls, instruments, load charts, viewing areas and existing warnings unobstructed. Do not apply the decal to insulating components without manufacturer approval.
Check the chart before ordering
Compare every printed distance, zone and provision with the chart required for your specific application. The printed distances are not universal clearance rules, and this decal does not identify line voltage, establish permission to work or confirm that equipment is insulated. It does not replace current manufacturer instructions, utility coordination or a site-specific work assessment.
For help matching an original label,
contact us with a clear photo, dimensions and equipment details.
