Crane Remote Control Electrocution Hazard Sticker

This crane remote control electrocution hazard sticker warns that the remote control does not provide protection against electrocution. Its horizontal red, black and white layout pairs a rectangular DANGER header and triangular alert symbol with an illustration of an operator holding a corded control near a crane and electrical lines.

Printed Remote Control Warning

DANGER

This remote control does not provide any protection against
ELECTROCUTION HAZARD

DEATH OR SERIOUS INJURY
Will result if the boom, load or load line should become electrically charged while you hold this control.

MAINTAIN SAFE CLEARANCES FROM ELECTRICAL LINES

This is the warning printed on the label, not a product promise of protection. The decal does not list voltage-specific clearance distances or include a clearance chart. Confirm applicable clearance requirements and operating procedures with the qualified person responsible for the work and your equipment instructions.

Remote Control Warning Decal Details

• Size: 6 inches wide × 3 inches tall
• SKU: ECr-001
• English-language horizontal design
• Corded remote-control electrocution illustration
• Laminated vinyl decal
• Created, printed, cut and shipped in the USA

Choosing Your Replacement Sticker

Match the dimensions, wording and illustration to your crane or boom truck manufacturer's replacement-label requirements. This is an electrical-hazard warning label, not a remote button legend, directional-control label or replacement remote control.

The artwork depicts a corded control. Do not assume the same label is required for every wired or wireless remote-control system; follow the manufacturer’s specified warning for your equipment.

Recommended Placement

For a corded crane remote-control system, we recommend using the original manufacturer-designated label position when known. If choosing a replacement-label location, consider a visible flat area on the control housing that can accommodate the full 6 × 3-inch decal and be read before use without covering buttons, emergency stops, indicators, grip areas, identification plates or existing instructions.

If the control housing cannot accommodate the label, consult the manufacturer’s decal-location guidance for an appropriate control-station location. A nearby warning should be visible to the remote operator before handling the control, not placed solely inside a cab that the remote operator may not enter.

These are general recommendations, not verified factory positions for every model. Follow the manufacturer's guidance and the decal’s application instructions; prepare a clean, dry surface.

This sticker communicates a warning. It does not provide insulation or electrical protection, prevent accidents or establish OSHA, ASME or ANSI compliance. It does not replace training, job planning, equipment instructions or required hazard controls.

Compare Other Crane Electrical Warnings

For a different crane electrical-hazard design with a voltage chart, compare the EC-001 crane electrical hazard sticker. For a Table A power line clearance chart design, compare the EC-002 power line clearance requirements sticker. These labels serve different warning purposes and are not automatically interchangeable replacements.