Crane Outrigger Setup Warning Sticker – Safety-Alert Danger Header, I-013

This crane outrigger safety sticker warns about improper setup before lifting on outriggers. I-013 reminds operators to check pin and float installation and outrigger-beam extension. The adhesive vinyl decal measures 4¾ inches wide × 3¾ inches tall.

Printed setup instructions

DANGER

DEATH OR SERIOUS INJURY COULD RESULT FROM IMPROPER CRANE SET-UP ON OUTRIGGERS.

ENSURE ALL PINS AND FLOATS ARE PROPERLY INSTALLED AND THE OUTRIGGER BEAMS ARE PROPERLY EXTENDED BEFORE LIFTING ON OUTRIGGERS.

Choose the matching header and replacement

I-013 has a rectangular red danger header with white lettering and a white safety-alert triangle. For the same setup message with an oval OSHA danger header, see I-013O.

Listed as a non-OEM replacement reference for crane sticker 7376007443. Compare the complete wording, header design, and 4¾ × 3¾-inch dimensions with the label specified for your equipment; the reference alone does not establish fit for every crane model.

A setup reminder, not a stand-clear warning

This decal addresses checks before lifting, not the separate crushing hazard during outrigger extension or retraction. Its instruction says “properly extended”; it does not specify one extension position for every lift. Follow the equipment manufacturer’s setup instructions and applicable load chart for the actual configuration.

For replacement placement and label quantity, use the manufacturer’s decal-location information rather than assuming one sticker per outrigger. Apply to a suitable clean, dry surface where the setup message can be read without covering controls, load charts, or other required information. The warning label does not establish correct setup, load capacity, or equipment compliance.

Need help comparing the artwork or dimensions? Contact us before ordering. Created, printed, cut, and shipped in the USA.